What are the steps to use the Comb binding machine

What are the steps to use the Comb binding machine?

The binding specification of the Comb binding machine refers to the maximum punching width and punching area, that is, the maximum width between the binding pinholes used in a binding process and the area of one pinhole.

What are the steps to use the Comb binding machine?

How to use the Comb binding machine?

What are the precautions for using the Comb binding machine?

What are the steps to use the Comb binding machine?

Amount of paper: It must be determined according to the amount of paper specified in the manual of each model, and cannot be excessive. Otherwise, the following undesirable situations may result:

①The handle cannot be pressed down, and the paper is blocked and cannot be penetrated.

②The margins are not balanced, and it is easy to cause paper edge curling.

③ Cause the square shaft to be twisted and shorten the service life of the binding machine.

The principle of adjusting the paper margins is to determine the margin size according to the diameter of the pull ring.

The method is to use the adjusting screw (installed behind the binding machine) to adjust the scale to achieve the purpose of the margin.

The rule is the larger the diameter of the ring, the larger the margin of the paper, the smaller the diameter of the ring, the smaller the margin of the paper.

How to use the Comb binding machine?

The usage of the Comb binding machine is as follows:

1. Binding method

When binding, turn the presser foot handwheel clockwise to raise the presser foot, put the binding material under the presser foot, release the presser foot handwheel at the selected position, and automatically press the presser foot handwheel, and then turn the presser foot handwheel counterclockwise. After locking at ~180°, turn the staple handle counterclockwise, and the staple goes through the material. When the penetration is in place, the lead arm will automatically hang the thread in the thread slot of the staple hook. At this time, the handle is lifted up. When the staple is withdrawn, the binding thread will follow through the binding material and release in a clockwise direction. Press the foot hand wheel to complete one stitch binding, repeat the above procedure, and the binding task can be completed immediately.

Second, the needle method

Loosen the fixing screw on the stitcher, remove the stitcher, hang the hook at the end of the stitch into the fixing hole of the stitcher, keep it vertical, put the stitcher into the original position of the stitching rod, and place the stitcher on the stitcher. the set screws are tightened.

What are the precautions for using the Comb binding machine?

1. Before punching the document with the Comb binding machine, first check whether the text has been placed in the correct position, and the amount of paper punched each time should not exceed the specified amount of the punch binding machine.
2. Special attention should be paid to the punching of the Comb binding machine: the strength of the hand should be uniform and the speed should be moderate.
3. During continuous operation, if the punching is laborious, the operation should be stopped immediately (this is the knife formed by the scraps of paper), and the operation can be continued after cleaning the scraps of paper.

For more information about Comb binding machine, please contact Ruian Koten Machinery Co.Ltd has committed to providing the increasing of Comb binding machine and making them more effective, reliable, and consistent.